Boxes.py

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

height above the wall in mm

height of hole(s) in percentage of maximum hole height (handle height - 2 * material thickness)

width of hole(s) in percentage of maximum hole width (width of edge - (n+1) * material thickness)

added to side panels if checked, to front and back otherwise (only used with top_edge parameter)

radius of corners in mm

extend the handle along the length of the edge (multiples of thickness)

angle at which slots are generated, in degrees. 0° is vertical.

depth of the slot in mm

extra slack (in addition to thickness and kerf) to help insert dividers in mm

radius of the slot entrance in mm

margin between box's bottom and divider's in mm

play to avoid them clamping onto the walls (in multiples of thickness)

sections left to right in mm 🛈

sections back to front in mm 🛈

inner height in mm (unless outside selected)

treat sizes as outside measurements 🛈

generate the same notches on the walls that are on the dividers

generate wall on the left side

generate wall on the right side

generate wall on the bottom

add handle to the bottom

thickness of the material (in mm) 🛈

format of resulting file 🛈

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

print surrounding boxes for some structures 🛈

label the parts (where available)

print reference rectangle with given length (in mm)(zero to disable) 🛈

style for inner corners 🛈

burn correction (in mm)(bigger values for tighter fit) 🛈